With about half of Siler City's homes built before 1980, a dripping faucet here is often an older two-handle fixture with worn washers or a shutoff valve that hasn't been turned in years. Most can be repaired, and a few are better replaced. Call the number on this page to be connected with a local plumber in Siler City.
Siler City at a glance
Siler City is a western Chatham County manufacturing town whose median home was built in 1980, with a large share from the 1950s. Water now comes from TriRiver Water, which absorbed the town's utility in 2025 and treats it at the Siler City filtration plant from the town's reservoirs. That supply is sensitive to drought, and dry spells have brought voluntary restrictions before. A faucet that drips all day wastes water at any time, but especially when TriRiver is asking customers to cut back.
What to do right now
- Find the stop valves under the sink. Turn them clockwise gently. If they won't move or start to leak at the stem, stop and use the main shutoff instead.
- Locate the main shutoff. In older homes it's often in a crawl space or near where the line enters the house.
- Plug the drain. Small screws and washers are easy to lose if you take the handle apart.
- Check the aerator. If the problem is weak or sputtering flow, unscrew the tip and rinse the screen.
- Take a photo. A picture of the faucet, its brand mark and the valves below helps the plumber bring the right parts.
Symptom and likely cause
| What you notice | What's probably behind it |
|---|---|
| Spout keeps dripping when closed | Worn washer or seat (two-handle) or cartridge (single-lever) |
| Water around the handle | Worn stem packing or O-ring |
| Handle spins without shutting off | Stripped stem or broken cartridge |
| Flow weak at one tap only | Clogged aerator or partly closed stop valve |
| Wet cabinet floor | Leaking supply line, stop valve or faucet connection |
| Outdoor spigot leaks after a freeze | Split valve body or cracked pipe behind the wall |
What affects the cost
- Repair or replace. Washers and cartridges cost less than a new faucet and installation.
- Older fixtures. Faucets from the 1950s through 1970s may need hard-to-find stems or may not be repairable.
- Valves and supply lines. Seized stops are usually replaced during the same visit.
- Access. Rusted fittings and tight cabinets take longer.
Chatham County Central Permitting & Inspections handles plumbing inspections for Siler City if a larger job calls for one.
Faucet Repair questions in Siler City
What usually makes a faucet keep dripping after it's turned off?
The little valve under my sink won't budge. Is it safe to force it?
When is a new faucet a smarter buy than repairing the old one?
An outside spigot began leaking after a cold snap. What went wrong?
More plumbing services in Siler City
Faucet Repair nearby
Helpful guides
Sources
Last updated: